Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Repair Across Kensington
Chimney repair in Kensington usually starts with a camera. The rowhouses packed along this part of Philadelphia were built when coal was the fuel, and their chimneys were never designed for what homeowners vent into them today. That’s why our first step is a Level 2 inspection, with footage you can watch yourself. We know these blocks well, from the tight party-wall stacks off Kensington Avenue to the converted buildings near Front Street, and we know the freeze-thaw winters that crack crowns and loosen mortar here. When you call (833) 962-9222, we answer 24/7.
Why Kensington Homeowners Call Chimney Sweep Frankford for Chimney Repair
Chimney work is all we do. Every job our technicians take on is a chimney or fireplace job, which means we diagnose the whole system instead of guessing at the symptom. Our technicians have up to 15 years of experience, and we work with the professional-grade product lines chimney pros rely on: DuraFlex, HeatShield, Gelco, and Olympia Chimney among them. That matters in Kensington, where the failure modes are specific: coal-era flues, shared stacks, and mortar that has taken decades of weather.
We handle the full lifecycle, from annual sweeping to cap and crown work, liner installation, masonry rebuilds, and fireplace repair, so you don’t need a second contractor halfway through. Single-source accountability is the point. The same specialist team that inspects your Kensington chimney is the one that repoints it, reseals the crown, or relines the flue.
What you’ll hear most from us is a plain answer and a written estimate. We put the flat price in writing before anything is booked, and nothing gets recommended unless the camera footage shows the problem clearly enough for you to see it yourself.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Repair Services in Kensington
We focus on four repair services that come up again and again on Kensington’s brick rowhouse chimneys: chimney repair that starts with mortar, waterproofing, and flashing, plus the rebuild work that follows when those are ignored.
Mortar Repointing in Kensington
Philadelphia’s freeze-thaw winters are hard on the mortar joints of an older Kensington chimney. Water gets into a hairline crack, freezes, expands, and by spring the joint is crumbling. Repointing cuts out that failed mortar and repacks it with fresh material matched to the brick, which stops the decay before it reaches the wythes behind it.

Spalling Brick Repair in Kensington
Spalling is the face of a brick flaking off, and on Kensington’s 19th- and early-20th-century rowhouses it usually traces back to water getting in and staying in. We identify the source first, whether that’s a cracked crown, failed flashing, or a joint that’s been letting moisture through for years, then replace only the bricks that are actually damaged. Patching the symptom without fixing the water is how a repointing job turns into a rebuild two winters later.

Chimney Waterproofing in Kensington
A breathable waterproofing treatment on the masonry slows water absorption without trapping moisture inside the brick, which is the balance older Kensington chimneys need. It’s a good step after repointing and crown repair, not a substitute for either. On a humid Kensington summer, an untreated chimney wicks moisture in through every open joint.

Flashing Repair in Kensington
Flashing is the metal that seals the chimney to the roof, and on a tightly packed Kensington rowhouse block, a flashing failure doesn’t just affect you. Water can travel along the shared roofline and show up as a stain on the neighbor’s ceiling. We repair or replace the flashing where it meets the roof, seal it properly, and check that the repair hasn’t pushed water toward the adjoining address. Related rebuild work and tuckpointing follow the same logic: fix the water path first, then restore the masonry.
Trusted Brands We Service in Kensington
We install and work with DuraFlex, HeatShield, Gelco, Olympia Chimney, Famco, and Copperfield, all professional-tier lines chosen by credentialed chimney technicians rather than sourced from a big-box shelf. We don’t claim to keep parts in stock, and we don’t pretend every flue needs the same product. What we can do is inspect the flue, show you the footage, and recommend the right listed liner or restorative system for what’s actually there. If the camera shows a HeatShield application will restore the flue, that’s often a far smaller job than a full reline, and we’ll say so.
See the difference
Before
After
Before
After
Before
AfterCommon Chimney Repair Problems We See in Kensington Homes
- One stack, two addresses. On Kensington’s attached rowhouse blocks, a single masonry stack often serves two homes through a shared party-wall chimney. Relining or capping one side without coordinating with the neighbor can damage the other flue or let water and combustion gases cross over.
- Coal-era flues venting modern appliances. The flues in these 19134 rowhouses were built unlined or with a single clay tile, sized for a coal stove, not a later gas furnace or water heater. An appliance venting into a shaft never designed for its exhaust is a back-drafting and carbon monoxide concern.
- Spalling mortar after freeze-thaw. Philadelphia’s winters work water into every joint and crack, so crumbling mortar, cracked crowns, and efflorescence on the bricks are a recurring spring issue before heating season starts.
- Nesting in uncapped flues. Once heating season begins, birds and raccoons moving into open flues is a standard call across Kensington, and an obstructed flue is a real safety failure, not a nuisance.
Pricing for Chimney Repair in Kensington, PA
Chimney repair in Kensington runs roughly $250 to $600 for a targeted repointing or flashing repair, and $3,000 to $8,000 or more for a full rebuild, depending on how much of the stack has to come down. That’s a wide spread, and it’s honest: a repoint on a crown and a few joints is a different job from rebuilding a shared stack that serves two addresses. Here’s what’s typical in Kensington’s market:
- Mortar repointing: roughly $300 to $900, scaled to how many joints and how high the work goes.
- Spalling brick repair: roughly $400 to $1,200, driven by the number of bricks replaced.
- Chimney waterproofing: roughly $250 to $500 for a standard rowhouse chimney.
- Flashing repair: roughly $250 to $600, more if the roofline is complex.
- Chimney rebuild: roughly $3,000 to $8,000 or more, depending on how far the damage extends below the roofline.
Every estimate is free, and we put the flat price in writing before we book. The written estimate sets the final price.
We Also Serve Cities Near Kensington
Kensington sits close to several neighborhoods where the chimney stock is every bit as old, and we serve them all. If you’re in Port Richmond, Frankford, Hunting Park, or Olney, the same camera-first approach applies. We connect homeowners across Kensington and these nearby communities with the same specialist team. Call (833) 962-9222 to get started.
Serving Kensington, PA – Our Local Coverage Area
We serve Kensington and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Repair in Kensington
Because on Kensington’s attached rowhouse blocks, one masonry stack often serves two addresses through a shared party-wall chimney, so any relining or capping work can affect the adjoining flue. Coordination before the work starts protects both homes and prevents damage to the neighbor’s flue. Call (833) 962-9222 for a free estimate.
No. An unlined or single-clay-tile flue doesn’t automatically mean a full reline; the decision should follow what a camera inspection actually shows, not a contractor’s word alone. A HeatShield restorative application may be enough in some cases, and a full DuraFlex liner may be right in others. Call (833) 962-9222 and we’ll show you the footage before recommending anything.
Ask to see the camera footage and ask where on the flue the creosote grade was measured, because a rebuild recommendation should be backed by footage you can watch, not a verbal claim. We run a Level 2 inspection with a camera and walk you through what it shows before any work is discussed. Call (833) 962-9222 for a free estimate.
Freeze-thaw cycling. Water works into hairline cracks and open joints, freezes, expands, and pushes the mortar loose, and Philadelphia’s winters repeat that cycle until the joint fails. Left alone, that decay reaches the brick and turns a repoint into a rebuild. Call (833) 962-9222 for a free estimate.
It starts with removing the nest and debris, inspecting the flue for damage the animal may have caused, and installing a cap sized to the flue so it doesn’t happen again. An obstructed flue is a safety issue, so we handle removal before anything else gets repaired. Call (833) 962-9222 for a free estimate.
If your Kensington chimney has crumbling mortar, a cracked crown, or a flue you’ve never had inspected, don’t guess and don’t take a full reline on a contractor’s word. Call (833) 962-9222. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday, and estimates are free.
Written by the team at Chimney Sweep Frankford.