Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Liner & Rebuild Across Narberth
Chimney liner and rebuild work in Narberth isn’t a cleaning job with a pressure-washer attachment. It’s diagnostic work on venting systems that were built to standards nobody enforces anymore, and on newer factory-built fireplaces whose parts have to match the maker. We handle both ends of that range: stainless steel liner installation and liner replacement on century-old flues, and partial rebuilds that put a masonry chimney back together before the next freeze splits it further. When we pull up to a Narberth address, the work starts with the system, not the symptom. Call (833) 962-9222 for a free estimate.
Why Narberth Homeowners Call Chimney Sweep Frankford for Chimney Liner & Rebuild
Chimney work is all we do, and that focus shows up most clearly on liner and rebuild jobs. A worn flue, a corroded chase cap, a swapped termination part, a masonry joint that’s letting in water: these are the problems a chimney specialist reads in minutes and a generalist misdiagnoses for weeks. From annual sweep to full liner rebuild, one specialist handles it start to finish, so there’s no handoff between a sweep company and a mason.
We work with the brands chimney pros rely on: DuraFlex for flexible stainless liners, HeatShield for ceramic restorative repair, Olympia Chimney and Famco for the parts that have to sit correctly inside a chase. Our technicians have up to 15 years of experience, and every liner and rebuild job is quoted by a written estimate you can read before anything starts.
We’re familiar with the streets here: the tight lots off Haverford Avenue and Narberth Avenue, the walkable blocks around the train station, the steep roof pitches that make access part of the estimate rather than an afterthought. Serving Narberth means working around those conditions every day, not learning them on your roof.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Liner & Rebuild Services in Narberth
Liner Replacement in Narberth
When the existing flue has failed its inspection, replacement is usually the safer path than a patch. We pull the old liner, check the flue’s interior dimensions and the appliance’s requirements, then size the new liner to match rather than to whatever’s in stock. In Narberth’s older homes, that often means finding that a clay-tile liner has cracked or spalled and no longer gives the clearance a wood-burning or gas appliance needs.
Stainless Steel Liner Installation
A stainless steel liner gives a chimney a continuous, sealed flue from the appliance to the top, which matters when the original masonry can’t be brought back into service. We work with DuraFlex liners and match the component grade to the fuel type. On newer Narberth homes with factory-built fireplaces, we also confirm the liner and termination parts match the appliance maker’s spec, since a mismatched install will draft poorly even when the chimney looks intact.
Flexible Liner Work
Flexible liners are the practical answer for many of Narberth’s flues because they can be sized and routed through existing chimney interiors without a full masonry teardown. Correct installation requires knowing what’s inside the chase, which is why we inspect with a camera before sizing. A flexible liner that’s mismatched to the appliance or under-supported at the top can loosen, lose draft, and cause smoke rollback.
Partial Rebuilds
Partial rebuilds address the parts of a chimney that fail first: the crown, the top courses of brick, a damaged cap or chase cover, a leaking flashing at the roof line. On Narberth’s pre-1900 masonry chimneys, freeze-thaw cycles have usually opened a few joints by the time anyone checks. On newer factory-built chimneys, the chase cap and storm collar are the usual culprits. We repair what failed with compatible materials and leave the rest of the chimney for a full rebuild if it needs one later. For the full range of what we handle, see our Chimney Liner & Rebuild service page.
Trusted Brands We Service in Narberth
We install and work with HeatShield, Gelco, Olympia Chimney, and Famco, along with DuraFlex stainless liners. The point isn’t brand-dropping. It’s that liner sizing, chase caps, and termination components have to come from professional-tier manufacturers who make parts that fit specific appliance systems; a generic substitute from a home center is what causes draft problems down the road. We can’t promise a specific part for every appliance, but we will tell you what your system needs and why. The work is quoted upfront and scheduled around the inspection findings.
See the difference
Before
After
Before
After
Before
AfterCommon Chimney Liner & Rebuild Problems We See in Narberth Homes
- Corroded or loose chase caps on factory-built fireplaces. Prefabricated chase caps and storm collars corrode or work loose over several freeze-thaw seasons. When they do, shoulder-season damp gets into the flue and you get downdrafts, creosote odor, and weak draft at the damper.
- Mismatched liner sections and termination parts. A prior repair may have swapped in a liner component or cap that doesn’t match the appliance maker’s requirement. The chimney looks sound from the ground, but the appliance no longer drafts to spec, and smoke rolls back into the room at the damper.
- Improved reseating of chase components after any job. Tight lot lines and steep slate or standing-seam roofs mean the cap or flashing has to be reseated correctly once work is done. If it isn’t, water gets in and the problem reappears on the next freeze cycle.
- Spalling masonry on pre-1930 chimneys. Narberth’s oldest homes have original brick flues that have absorbed decades of moisture. Spalling brick and washed-out mortar joints mean a liner sized for the original flue may no longer have the clearance it needs.
Pricing for Chimney Liner & Rebuild in Narberth, PA
Pricing is quoted per job by written estimate, not by a flat rate that ignores what the chimney actually needs. Typical Narberth ranges: a stainless steel liner installation for a standard flue usually falls in the $1,800 to $4,000 range; a flexible liner for a factory-built fireplace typically runs $900 to $2,200; partial rebuild work (crown, top courses, chase cap or flashing) usually comes in between $700 and $3,500; and a full chimney rebuild on a masonry flue commonly runs $6,000 to $15,000 or more, depending on height and condition. Tight-lot access, roof pitch, and shared or party-wall flues on twins near the train station all affect the estimate. The written estimate you get is the price. The estimate visit itself is free.
We Also Serve Cities Near Narberth
Narberth sits in a cluster of Main Line boroughs and townships we cover, and the same liner and rebuild principles apply to neighbors: Merion Station, Penn Wynne, Overbrook, and Millbourne. Some have the same age and roof pitch as Narberth; others have newer housing stock. The inspection and the estimate process are the same regardless. If you’re outside Narberth and want a free estimate, call and we’ll tell you what we can schedule.
Serving Narberth, PA – Our Local Coverage Area
We serve Narberth and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Liner & Rebuild in Narberth
We schedule estimates around Narberth and the surrounding Main Line towns with fast dispatch from 7am to 7pm, Sunday through Friday, and our phones answer 24/7. When you call, we’ll book the earliest opening that works with your schedule. Call (833) 962-9222 for a free estimate.
We cover all of Narberth, from the residential blocks along Haverford Avenue and Narberth Avenue to the streets around the train station and the borders touching Penn Wynne and Merion Station. The tight lots and steep rooflines don’t change our coverage; the estimate visit and staging approach will account for them. Call (833) 962-9222 and tell us your cross street.
Same-day liner installation or rebuild work is possible when the inspection findings and job scope allow it, and we’ll be upfront at the estimate appointment about what’s realistic. Chase-cap work and minor partial rebuilds often go in one visit; full liner replacement on a complex flue may need a second. We answer 24/7 for calls, with fast dispatch from 7am to 7pm, Sunday through Friday.
Cost differences across Narberth, Penn Wynne, Overbrook, and Millbourne usually come down to access and chimney condition, not location markup. Steep slate or standing-seam roofs, tight driveways, and party-wall flues near the train station all require ladder stands, roof jacks, and extra time to stage a liner safely. Homes with newer factory-built fireplaces usually price lower than century-old masonry, where access and brick condition both add estimated cost. Call (833) 962-9222 for a free estimate and a written range.
The estimate visit is free and includes a camera inspection and photo report of the flue, cap, and any chase components that need work. Nothing is recommended without visual evidence you can see for yourself, and we’ll tell you plainly when work can safely wait. The written estimate sets the final price, and the local pro performing the work is licensed and insured as Pennsylvania requires. Call (833) 962-9222 to book.
A partial rebuild replaces just the failed section (typically the crown, chase cap, flashing, or the top few courses of brick), while a full rebuild tears down and rebuilds the entire chimney above the roof line. Partial rebuilds usually run $700 to $3,500 in Narberth; a full masonry rebuild commonly runs $6,000 to $15,000 or more. The camera inspection and photo report tell you which is actually needed. Call (833) 962-9222 for a free estimate.
If your liner or chimney is sending signals (a smoke smell when the fireplace is cold, a loose chase cap you can see from the yard, spalled brick at the top), the next step is an inspection that tells you what you’re actually looking at. Call (833) 962-9222 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Chimney Sweep Frankford.