Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Cap & Crown Across Kensington
If you own a rowhouse in Kensington, your chimney was probably built for a coal stove and has been asked to do a very different job ever since. Caps rust out, crowns crack, and flues that were never lined start letting water and weather into brick that’s already a century old. We handle chimney cap and crown work in Kensington with camera evidence first, so you see the problem before anyone quotes a fix. Call (833) 962-9222. We answer 24/7, and fast dispatch runs from 7am to 7pm, Sunday through Friday.
Why Kensington Homeowners Call Chimney Sweep Frankford for Chimney Cap & Crown
Chimney work is all we do. That focus matters on Kensington’s older blocks, where the diagnosis is rarely as simple as “replace the cap.” A dense run of two- and three-story brick rowhouses on shared party walls means the flue serving your address may be tied to the one next door, and getting that wrong sends a repair – or a leak – into a neighbor’s unit. We work through chimney cap & crown jobs with a Level 2 inspection and camera documentation before recommending anything, so you’re never asked to take our word for a repair you can’t verify.
Our technicians have up to 15 years of experience reading exactly these systems: coal-era flues later rigged for gas, rear additions with undocumented runs, and converted industrial buildings where nobody kept a record of what vents where. We serve Kensington and the surrounding neighborhoods, and the local pro we connect you with is licensed and insured as their state requires. From annual sweep to full liner rebuild, it’s one specialist, start to finish. No second contractor, no handoff.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Cap & Crown Services in Kensington
Caps and crowns are the top of the system, and on Kensington’s brick rowhouses they take the worst of it. Here’s what each piece of the work involves.
Cap Installation
A properly sized cap keeps rain, birds, and raccoons out of the flue while letting smoke and combustion gases escape. On a narrow Kensington rowhouse chimney, an off-the-shelf cap rarely fits the flue count or the masonry footprint. We size the cap to the actual flues in the stack, not to a guessed measurement, and we check that a dormant flue isn’t left open when we set it.

Cap Replacement
Rusted-out and missing caps are some of the most common calls we get in Kensington once heating season starts, because an open flue is an invitation. If a cap has failed, the flue underneath needs a look before a new one goes on – water and nesting debris may have already reached the parging. We replace the cap and confirm the flue is still sound and drafting the way it should.

Crown Repair
The crown is the sloped mortar top that sheds water away from the brick. When it cracks, water runs straight into the masonry and the flue beneath it. On tightly attached Kensington rowhouses, a repair also has to direct water away from the neighbor’s half of a shared chimney, not toward it. Crown repair is one of the jobs we emphasize here precisely because the shared structure makes it delicate.

Crown Coating
A crown that’s cracked but structurally intact can often be coated rather than rebuilt. We use restorative coatings from HeatShield and Gelco to seal the surface and close hairline cracks before water gets in. Coating is also an option on a shared chimney when both sides of the crown need protection and a full rebuild would be overkill.
Trusted Brands We Service in Kensington
We work with the professional-grade brands chimney technicians actually rely on for caps, crowns, and liners – HeatShield, Gelco, Olympia Chimney, and Famco among them. These are the materials specified for the job, not big-box parts chosen to hit a price. We don’t stock parts on a truck or keep a local warehouse; the right cap or crown material is ordered to your chimney’s measurements. That usually means a fast turnaround once the inspection is done and the estimate is approved. If your Kensington rowhouse needs a custom cap for an irregular stack, we can spec that too.
See the difference
Before
After
Before
After
Before
AfterCommon Chimney Cap & Crown Problems We See in Kensington Homes
- Shared party-wall chimneys. Many Kensington chimneys serve two addresses, and a crown repair on one side can inadvertently push water into the neighbor’s flue. We verify the shared structure on camera before touching either side.
- Unlined coal-era flues capped without repair. Original flues with spalling mortar sometimes get a new cap while the deteriorated parging underneath is ignored. That traps a hidden problem, and it can mean carbon monoxide finding its way through the brick instead of out the top.
- Missing or undersized caps. An open flue on a Kensington rowhouse draws birds and raccoons, and nesting material blocks the draft. A blocked flue is a fire hazard, not just a nuisance.
- Cracked and slumped mortar crowns. Philadelphia’s freeze-thaw winters and humid summers work on aging mortar, so crown cracks and water intrusion into unlined flues are a recurring spring and fall issue right before heating season.
A typical Kensington call goes like this: a homeowner notices water stains near the chimney breast after a spring rain, and the inspection turns up a cracked mortar crown and a missing or rusted cap letting water into an unlined clay flue. The usual fix is to rebuild or coat the crown and install a properly sized multi-flue cap – but only after a Level 2 inspection with camera documentation confirms the flue and the shared party-wall condition.
Pricing for Chimney Cap & Crown in Kensington, PA
Estimates here are per job, set by a written estimate after inspection, and the estimate itself is free. For planning, these typical ranges give you a realistic picture of the Kensington market. A single-flue cap installation generally runs $180 to $450 depending on flue count and fit. Cap replacement, including removal of a rusted unit, typically lands at $200 to $500. Crown repair starts around $350 and reaches $900 or more when the crown needs partial rebuild, and a multi-flue or custom cap for a wide shared stack commonly runs $500 to $1,200. Crown coating is usually the modest end of the crown range. What moves the number is flue count, access, and whether the party-wall side needs coordination. Nothing is recommended without camera evidence you can see for yourself, and if a repair can safely wait, we’ll tell you so.
We Also Serve Cities Near Kensington
Our chimney cap and crown work extends across the neighborhoods around Kensington, including Port Richmond, Frankford, Hunting Park, and Olney. The housing stock is similar – old brick rowhouses, shared chimneys, coal-era flues – so the same camera-first approach applies. If you’re just outside Kensington, call and we’ll confirm coverage for your address before booking.
Serving Kensington, PA – Our Local Coverage Area
We serve Kensington and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Cap & Crown in Kensington
Usually yes, but only after confirming which flues belong to which address, because a shared chimney means a cap on your side can affect the neighbor’s draft. On tightly attached Kensington rowhouses, the shared stack routinely serves two addresses, so we coordinate with the neighbor before relining or capping. A camera inspection establishes exactly what’s shared. Call (833) 962-9222 and we’ll walk you through what coordination is needed for your block.
Look for visible cracks, a crumbly or spalling surface, and water stains on the ceiling near the chimney breast after rain. Philadelphia’s freeze-thaw winters and humid summers beat on aging mortar crowns, so crown cracks and water intrusion are a recurring spring and fall issue before heating season. If you see any of those signs, a camera inspection is the next step. Call (833) 962-9222 for a free estimate.
Yes. An old Kensington chimney often has unlined or clay-tile flues, and capping one without checking the parging underneath can trap a hidden problem – including carbon monoxide finding its way through deteriorated brick. Camera documentation lets you see the flue’s condition yourself before anything is recommended. That’s how we avoid the upselling common in older neighborhoods. Call (833) 962-9222 to book an inspection.
A properly sized multi-flue cap that fits the actual flue count and the masonry footprint, not a one-size stock unit. Narrow Kensington rowhouse chimneys often carry several flues from the coal era, some capped, some dormant, some poorly relined – so the cap has to match what’s really there. We measure and spec the cap from the inspection. Call (833) 962-9222 for a free estimate.
A coating protects both sides only if the crown is intact on both halves and the cracks are surface-level, not structural. On a shared Kensington chimney, we inspect the full crown, document both sides on camera, and confirm whether coating will seal it or whether one side needs a rebuild. You and your neighbor both see the evidence before work begins. Call (833) 962-9222 for a free estimate.
If your Kensington rowhouse is due for a cap, a crown repair, or just a straight answer about what your chimney actually needs, call (833) 962-9222 for a free estimate. We answer 24/7, and fast dispatch runs from 7am to 7pm, Sunday through Friday. Camera evidence first, written estimate second, work only after you’ve seen the proof.
Written by the team at Chimney Sweep Frankford.