Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Cap & Crown Across Fox Chase
If the crown on your rowhouse stack has cracked along the mortar joint or your cap has rusted through, we can help. Chimney cap and crown work in Fox Chase usually starts with a camera inspection, because so many of these are attached brick rowhouses built between the 1920s and 1950s, where the stack you can see from the yard is only half the story. Most of these chimneys are shared party-wall flues, so what happens on your side of the mortar affects the house next door, and the other way around.
We know this ground. The tight streets off Rhawn Street and the blocks running toward Pennypack Park leave little room for a ladder setup, and the original terra-cotta stacks here were sized for coal before they were retrofitted for oil or gas. We work on none of the rest of the house. Chimney work is all we do, which means we see the party-wall problems generalists miss.
Call (833) 962-9222 to book an inspection. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Why Fox Chase Homeowners Call Chimney Sweep Frankford for Chimney Cap & Crown
Fox Chase homeowners call us because we treat a cap and crown job here as a shared-stack job, not a one-flue transaction. On these attached rowhouses, a single multi-flue cap usually has to span both flues at once, and we won’t order a cap until we’ve put a camera down your flue and checked the neighbor’s side of the stack. That’s a slower first visit than some outfits offer, and it’s the reason our bids hold up.
We’re a chimney-and-fireplace-only company. Every job we take is a chimney or fireplace job, from a routine sweep to a full liner rebuild, which is why we can move from a capped stack to a HeatShield liner repair without handing you to a second contractor. Our technicians have up to 15 years of experience, and we work with the professional-grade product lines chimney pros actually specify: DuraFlex, HeatShield, Gelco, Olympia Chimney, Famco, and Copperfield.
For Fox Chase specifically, that means we arrive knowing the local housing pattern. We know the parged interiors and offsets inside a 1940s twin. We know that original cleanout doors are often buried behind a finished basement, and that a seized damper may be hiding the top of the stack from you. Read more about our full chimney cap & crown work, or keep reading to see how it applies to your block.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Cap & Crown Services in Fox Chase
We handle every phase of cap and crown work on Fox Chase rowhouses and twins. Below are the services that come up most often here.
Cap Installation
A new cap goes on after we’ve checked the flue it’s protecting. On a Fox Chase rowhouse, that means running a camera down your side and looking at the party-wall side, because a proper stainless cap with a screen needs to sit over a flue that isn’t already cracked or spalling. We size the cap to the actual stack, not the catalog average.

Cap Replacement
Rusted-through caps and missing cap screens are common here. The original dampers are often seized and the cleanout doors buried, so the top of the stack is the only place many Fox Chase homeowners can see a problem. When we replace a cap, we check whether the crown underneath is still sound before we cover it up again.

Crown Repair
Cracked and spalling mortar crowns are the most frequent repair we make in Fox Chase. The exposed brick stacks on 1920s to 1950s rowhouses take freeze-thaw damage hard through Philadelphia’s winters, and a crack along the mortar joint lets water wick straight into the terra-cotta liner below. We remove the failed crown, repair the brick beneath, and repour with the proper overhang so water sheds off the stack instead of into it.

Crown Coating
When the crown is intact enough to save, a coating can buy it years. We use crown coatings where the masonry is sound and the damage is surface-level. On a shared party-wall stack, coating is often the right call because it doesn’t require rebuilding the full width of a crown that spans two households.
Trusted Brands We Service in Fox Chase
We install and work with professional-grade chimney products, including DuraFlex, HeatShield, Gelco, Olympia Chimney, and Famco. These are the brands chimney technicians specify, not the ones on the shelf at a big-box store. We don’t stock parts on a truck or in a warehouse; we measure the stack, order what fits, and schedule the install. On a Fox Chase party-wall chimney, that’s actually the right way to do it, because a multi-flue cap has to be sized for the actual offset stack, and no generic part will fit it. Once the material is in, install turnaround is quick. Fast dispatch from 7am to 7pm, Sunday through Friday.
Common Chimney Cap & Crown Problems We See in Fox Chase Homes
- Cracked and spalling mortar crowns on exposed 1920s-1950s brick stacks. Freeze-thaw water wicks into the terra-cotta liner and starts deteriorating the flue from the inside. Replacing a cap without repairing the crown underneath leaves the real problem in place.
- Single-flue caps fitted on shared party-wall stacks. These leave the neighbor’s abutting flue open to rain, animals, and downdraft. A proper multi-flue cap has to span both openings at once, which is why bids here start with a camera inspection of both sides.
- Seized original dampers and buried cleanout doors. These hide the top of the stack from the homeowner, so a rusted-through cap or missing cap screen goes unnoticed until water damage or a draft problem shows up indoors.
- Shared party-wall flues with failed parging. On attached rowhouses, a cracked flue tile or failed parging in one home’s chimney can leak smoke or carbon monoxide into the neighbor’s connected flue. Technicians here routinely camera-inspect and check the party-wall side, not just the homeowner’s own stack.
How a Typical Fox Chase Cap and Crown Job Usually Goes
On a typical Fox Chase rowhouse, the exposed brick crown at the top of the stack has cracked along the mortar joint and begun to spall, letting freeze-thaw water into the terra-cotta flue liner below. A qualified technician typically camera-inspects both the homeowner’s flue and the party-wall side, removes the failed crown, repours or coats a new crown with proper overhang, and sets a multi-flue cap sized for the offset stack. Because the same stack often carries a neighbor’s gas appliance vent, the tech also confirms the shared flue is sound so exhaust doesn’t migrate sideways. That last step is what separates a cap job from a shared-stack job, and it’s the one most likely to be skipped by a sweep-only outfit.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Cap & Crown in Fox Chase, PA
Here are typical ranges for this market. Your written estimate sets the final price.
- Single-flue cap installation: typically $150 to $350 installed, depending on cap size and material.
- Multi-flue cap (shared party-wall stack): typically $350 to $700, since the cap has to span both openings and be custom-fitted to the offset.
- Custom cap for irregular or offset stacks: typically $450 to $900, fabricated to the measured stack.
- Crown repair (remove, rebuild, repour): typically $350 to $800, scaled to the width of the crown and the extent of brick repair beneath.
- Crown coating: typically $250 to $550, when the masonry is sound enough to coat.
A party-wall stack that spans two households often lands at the upper end of these ranges because the crown and cap both have to cross the mortar joint. If the camera shows liner damage under the crown, the estimate will reflect the straight repair first and note what can safely wait. Nothing is recommended without camera evidence you can see for yourself. The estimate is free.
We Also Serve Cities Near Fox Chase
We work throughout Fox Chase and the surrounding Northeast Philadelphia neighborhoods and near suburbs, including Cheltenham Village, Oxford Circle, Mayfair, and Olney. The same party-wall rowhouse and twin pattern runs through most of these blocks, so if you’re on the edge of Fox Chase and aren’t sure which town we’d list you under, just call. The estimate is free either way.
Serving Fox Chase, PA – Our Local Coverage Area
We serve Fox Chase and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Cap & Crown in Fox Chase
Sometimes, but on most shared party-wall stacks a single-flue cap is the wrong fit. Because the two flues abut, a one-side cap leaves the neighbor’s opening exposed to rain, animals, and downdraft, and it can create a draft imbalance between the two flues. A proper multi-flue cap usually has to span both openings at once. We camera-inspect both sides before we recommend which way to go. Call (833) 962-9222 for an exact quote – estimates are free.
Because the crown is the part of the stack taking the full freeze-thaw cycle, and Philadelphia winters are hard on exposed 1920s to 1950s brick. When the mortar joint at the crown edge opens up, water gets behind it and freezes, and each season pushes the crack wider. A repour with proper overhang solves it; a patch alone won’t. We look at the brick beneath the crown too, not just the surface. Call (833) 962-9222 for an exact quote – estimates are free.
There isn’t a reliable visual test from inside your home, which is why we put a camera down the flue. On Fox Chase’s attached rowhouses, a cracked flue tile or failed parging in one home’s chimney can leak smoke or carbon monoxide into the neighbor’s connected flue, and you can’t see that from the firebox. A camera inspection of the party-wall side is the only way to know. Call (833) 962-9222 to book one – estimates are free.
Yes, especially on a shared stack. Water intrusion, a rusted-through cap, and a spalling crown don’t wait for you to light a fire. On these rowhouses, a crown that’s letting water into the terra-cotta liner keeps deteriorating whether or not the fireplace is in use, and the damage on the neighbor’s side matters to your flue. An inspection is the only way to catch it before it reaches the liner. Call (833) 962-9222 for an exact quote – estimates are free.
Often, but only if the cap and the crown are addressed together. A rusted or missing cap lets rain straight down the flue, and a cracked crown lets water wick in around the top of the stack. Replacing the cap alone on a Fox Chase rowhouse with a failed crown leaves the water path open. We check both before we bid, and we’ll tell you plainly when a repair can safely wait. Call (833) 962-9222 for an exact quote – estimates are free.
Book Your Fox Chase Cap and Crown Inspection
If your stack is shared with a neighbor, or you’ve noticed water, a rusted cap, or a cracked crown and you’re not sure how far the damage goes, the place to start is a camera inspection. You’ll see what we see, and the estimate is free. Call (833) 962-9222. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Chimney Sweep Frankford.